The reason it will be missing is the manufacturer or our flyers, have yet to provide the details needed about what hardware is on the board.Īfter updating to Betaflight 4.4.0, you MUST use the latest 10.9.0 Betaflight Configurator. This should give us enough information to at least get your target up and running with 4.4.0.

If your target does not present the 4.4.0 releases in 10.9.0 of the configurator, then please flash 4.3.2 and then submit a support request from within the CLI tab. Well done to the team who have pulled that together. There is a new website that houses all the documentation and media for helping you get the best out of Betaflight. Please read these important introductory notes:

IMPORTANT: Make sure you install and use the latest version of the Betaflight Configurator (10.9.0) before updating your firmware.

FIX CONFIG: Adding USE_FLASH to enable where hardware supports by in #12499.

FIX CONFIG: Adding USE_ACC, USE_GYRO and USE_BARO where appropriate.

Adding support for building by config by in #12376.

Add separate AAF values for ICM-42605 by in #12616.

Exclude MSP_OSD_CONFIG if USE_OSD not defined ( #12513) by in #12590.

Include smartport telemetry for Fport ( #12314) by in #12572.

Restore DShot Beacon control for 4.4 by in #12560.

DShot zero between beacon commands for 4.4, from 12544 by in #12555.

Blackbox (as applied to 4.5.0) by in #12520.Latest changes from unified targets, and sdcard build fix.Fix SDFT batchSize rounding by in #12332.Fix max permissible CMS rows and up/down page arrows ( #12277) by in #12284.Increase FF smoothing max to suit elrs 1000hz link rate ( #12426) by in #12433.GPS Rescue IMU adaptation 0.2 by in #12845.Handle invalid baro pressure values by in #12824.GPS Rescue Bugfix to ensure IMU adaptation to GPS course over ground by in #12821.fixes not working Ghost on F4xx ( #12809) by in #12811.If CS is asserted between transfers then consider bus to be busy for … by in #12784.Converge IMU faster at higher groundspeed during GPS Rescue by in #12785.Fix bootloader jump for g4 mcu ( #12675) by in #12783.Remove 15 m/s limit on estimated vario by in #12788.Tri-state USART TX output if load due to powered down peripheral is d… by in #12782.DSHOT timing improvements by in #12709.

Downloading ClassicDesktopClock 4.41